Table of Contents
Advertisement
4.4 Back Height Adjustment (Adjustable Back
Only)
Observe the tautness of the back upholstery for
reinstallation.
1.
Unlatch the two fastening flaps that secure the top of the back
upholstery to the back posts and remove from the back posts.
WARNING!
– Push pin MUST be protruding through hole in
back post B.
– Ensure that both back post inserts A are at the
same height BEFORE reassembling the wheelchair.
Press the push pin on the back post insert tube A in and adjust
2.
the back height to one of four heights depending on original back
height:
* Holes numbered from bottom to top for reference
only. (There are no numbers on the back posts.)
1171801-A
There is a 1-inch (2.54 cm) adjustment pin on the back post
insert tube A. To raise back to maximum height, first make
adjustment to the back post inserts A.
The fastening flap with logo is for the left back post B.
Right and left is determined by sitting in the wheelchair.
Reinstall the fastening flaps onto the back posts B.
3.
4.
Adjust the new back upholstery to the desired tautness.
9–11
10–14
Original
(22.86in
(25.40in
Back
– 27.9
– 35.5
Height
4cm)
6cm)
Hole* Number
9in
10in
1
(22.86
(25.40
cm)
cm)
10in
11in
2
(25.40
(27.94
cm)
cm)
11in
12in
3
(27.94
(30.48
cm)
cm)
13in
4
N/A
(33.02
cm)
14in
5
N/A
(35.56
cm)
Operation
12–16
14–18
16–20
(30.48in
(35.56in
(40.64in
– 40.6
– 45.7
–
4cm)
2cm)
50.8cm)
12in
14in
16in
(30.48
(35.56
(40.64
cm)
cm)
cm)
13in
15in
17in
(33.02
(38.10
(43.18
cm)
cm)
cm)
14in
16in
18in
(35.56
(40.64
(45.72
cm)
cm)
cm)
15in
17in
19in
(38.10
(43.18
(48.25
cm)
cm)
cm)
16in
18in
20in
(40.64
(45.72
(50.8
cm)
cm)
cm)
31
Advertisement
Table of Contents
