Communication Tourble - Muratec MFX-2550 Field Engineering Manual

4.4 Communication tourble

4.4.1 Fax communication error
The error code are printed on T.30 monitor.
Detail
Phase Error code
Error code
Tx Phase A D.0.1 0001
D.0.2 0002
D.0.3 0003
D.0.7 0007
D.0.8 0008
Tx Phase B T.1.1 1011
T.2.1 1021
T.2.2 1022
1100
1101
1102
1103
1104
1105
1106
1107
1108
1109
110A
110B
110C
110D
Description
Local busy detection. No
Busy Tone detected
Canceled transmission while dialing
Receiver does not answer
Can not detect dial tone
T1 time-out error Yes
Can not detect CFR or FTT
Compatibility error
Password transmission failed
Cannot obtain password at password
transmission from receiving party
The obtained password from receiver at
password transmission is blank
The receiver is a product of other maker
at closed communication
The receiver has no pass code field at
closed transmission
The pass code did not match at closed
transmission
No document stored for polling
The pass code did not match at pass
code polling
The receiver is a product of other maker
at pass code polling
Cannot adjust communication data rate
Cannot adjust the communication mode
(Normal, fine, super fine)
Cannot receive standard frame
DIS T4 bit did not turn ON
DIS or DTC that FIF is 00 00 00 has
been received. DTS requires hang up.
German models only.
Journal Redial
The sending was stopped. Please try again.
Yes
The line was busy. Please try again.
Fax job was cancelled by user.
No
Yes Check condition of remote fax.
No dial tone detection. Check line connection.
Only Confirm the remote fax.
when one
or more
pages are
received
No Confirm the remote fax.
Confirm the remote fax.
ID check Tx error. ID was not matched.
ID check Tx error. No fax number stored in remote fax.
Close Tx error. Remote fax is not compatible.
Close Tx error. No pass -code stored in remote fax.
Close Tx error. Passcode unmatched.
Polling Tx error. No document for polling is stored in
memory.
Close Tx error. Passcode unmatched.
Close polling Tx error. Remote fax is not compatible.
Confirm the remote fax.
Confirm the remote fax.
Confirm the remote fax.
4-7
Message
Occurs at broadcast with TCR.
This error occurs at manual
reception.
Normally, this error does not
occur.
Normally, this error does not
occur.
Note