Appliance Setup; Remove Fixed Glass Assembly; Remove The Shipping Materials; Clean The Appliance - Heat & Glo TRUE-36C Owner's Manual

14 14

Appliance Setup

A. Remove Fixed Glass Assembly
See Section 14.I.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
E. Install Teco-Sil and Mystic Embers
1. Install Teco-Sil along front edge of glass as shown in
Figure 14.1. Rock should follow contour cutout in the
front refractory.
Figure 14.1. Install Teco-Sil
2. Fill in the rest of the ember glass area by placing an
even layer of Teco-Sil across the bottom. Dropping the
Teco-Sil through the oval holes in the burner creates a
more even layer. See Figure 14.2.
3. Using a high temperature black paint, fog the Teco-
Sil to the desired look. See Figure 14.3. Prior to
painting, take precautions to prevent any overspray
from reaching the pilot assembly.
Heat & Glo • TRUE-36, TRUE-42, TRUE-50 • 2282-900 Rev. i •
NOTICE: Do NOT paint the pilot assembly!
Figure 14.2. Ember Glass Area Covered with Teco-Sil
Figure 14.3. Teco-Sil Painted
4. Apply Mystic-Embers around the ember bed and
hearth refractory. The joints in the front middle hearth
refractory can be concealed with these embers.
MYSTIC EMBERS MYSTIC EMBERS
Figure 14.4. Apply Mystic Embers
4/13
53