B. Splatter Guard
The splatter guard is a piece of corrugated material
used to protect the appliance during the installation
process before fi nishing work on the whole hearth is
complete. Splatter guards may be factory installed or
accompany the door of the appliance, depending on
the model. Splatter guards must be removed before
appliance is fi red.
WARNING! Risk of Fire! Close the ball valve before in-
stalling the splatter guard to prevent accidental lighting.
Remove the splatter guard before lighting the appliance.
1. Fold top fl ap along scored lines.
2. Slide side tabs into slots by sides of glass.
Figure 13.4 Finishing Templates Bends
Figure 13.5. Splatter Guard Installation
48
Heat & Glo •
TRUE-36, TRUE-42, TRUE-50 • 2282-900 Rev. i •
4/13