Hp Microserver Remote Access Card; Resetting The Microserver Remote Access Card Password To Default - HP ProLiant MicroServer User Manual

IMPORTANT:
non-hot plug. If the device is non-hot plug, you must power down the server. Non-hot plug devices
in the server include the processor, all boards, memory modules, fan, expansion boards, and all
system drives.
IMPORTANT:
compatible with the server. When you integrate new components into the system, record the
model number, serial number, and any other pertinent information for future reference. After
completing any removal or replacement procedure, run the diagnostics program to verify that all
components operate properly.

HP MicroServer Remote Access Card

The operating system has the BMC Setup function when the IPMI card is installed into the server. By BIOS
default, the server exports the VGA port through the VGA connector on the IPMI card automatically when the
IPMI card is plugged. You can use the RJ45 port (LAN port) on the IPMI card to connect the WebUI of BMC.
Resetting the MicroServer Remote Access Card password to
default
You can use the IPMI tool via KCS to reset the administrator password to "password."
Use the following Linux ipmitool command:
ipmitool raw 18 47 82 2 0x70 0x61 0x73 0x73 0x77 0x6f 0x72 0x64 0x00 0x00
0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x00
Before removing any serviceable parts, determine whether the part is hot plug or
Review the specifications of a new component before installing it to verify that it is
Hardware options installation 13