Turn Off The Power After Projection Is Finished - Taxan KG-PS232Xh User Manual

Basic Operation

Turn off the power after projection is finished

1
Turning Off the Projector Power
Press the POWER/STANDBY button of the remote control or the projector.
• This message will be displayed: Turning power off – Press "POWER/STANDBY" to
proceed. (Press "MENU" to cancel.)
• Following the message, a press of the POWER/STANDBY button will cause the
screen to go blank and will enter the projector into the power off operation.
• The POWER/STANDBY button must be pressed while the message is displayed
if the power is to be turned off.
• A press of the MENU button while the message is displayed will cause the mes-
sage to be deleted and will return the projector to the power On condition.
• The indicator of the POWER/STANDBY button will change to a flashing blue,
then go off about 90 seconds later, and the indicator will light in the orange of
the standby mode.
Power is On
2
Disconnect the Power Cable
When the Quick-off function is not being used, check that the indicator of the
POWER/STANDBY button is lit in orange and then disconnect the power cable.
When the power cable is disconnected, the indicator of the POWER/STANDBY but-
ton will go off.
3
Closing the Lens Shutter
Turn the lens shutter counterclockwise until it stops with a click sound.
E-38
Data Projector
Cooling down
The projector is equipped with a Quick-off function. Even
when the power cord is unplugged soon after turning off
the power, the internal power supply will power the rotation
of the cooling fan and cool the lamp allowing immediate
removal.
•
•
Standby Mode
Technical Point
After cooling the projector with the power cable con-
nected, relighting of the lamp might become difficult.
Do not place the projector in a bag or other enclosure
while the cooling fan is turning.