Preparing The Remote Control; Installing The Batteries (And Battery Replacement - Taxan KG-PS232Xh User Manual

Check before Use

Preparing the Remote Control

Installing the Batteries (and Battery Replacement)

The projector and the batteries are packaged separately. Insert the batteries in the remote control before use.
When it is time to replace the batteries, do so using the same procedure.
1.
Open the cover of the battery
case located on the back of the
remote control.
Precautions
• Use the same type of replacement batteries as the supplied AA batteries. There is danger of explosion if different battery types are used.
• Dispose of used batteries according to the local regulations.
Note
• Exposure of the main unit's remote control sensor or the remote control infrared transmitter to bright light or the obstruction of the signal by an obstacle located in the
pathway may prevent operation. To prevent operational difficulties with the sensor when the projector is installed suspended from the ceiling, install the projector 1.5
m (4.9 feet) or further from fluorescent lighting.
• The remote control will not function properly when the batteries are weak.
E-20
Data Projector
2.
Insert the batteries so that +
and − ends match the markings
inside the case.
3.
Close the cover of the battery
case.