Installation Instructions - Splendide WD2000S Training Manual

Follow these instructions in order to prevent installation errors and to assure proper washer-dryer operation.
!
WARNING
EXCESSIVE WEIGHT HAZARD
Use two or more people to move
and install the washer-dryer.
Failure to do so can result in back
or other injury
Remove the Transit Screws/Spacers
First, position the washer so that the rear of the unit is within
approximately 3 feet (90 cm) of the fi nal location. There are 4 bolts
in the rear panel of the washer that support the suspension system
during transportation.
1. Using a 13mm socket, loosen each of
the bolts.
2. Once loosened, pull out the bolt,
including the rubber grommet and
the plastic spacer covering the bolt.
3. Once all 4 bolts are removed, close the holes with the transit
bolt hole plugs (provided).
4. Keep the bolts, rubber grommets and plastic spacers in a safe
place. These items should be reinstalled if the machine is
transported in the future.

Installation Instructions

Route the Drain Hose
Proper routing of the drain hose protects your fl oors from damage
due to water leakage. Carefully read and follow these instructions.
The drain hose is connected to the washer:
Drain Hose
To prevent drain water from going back into the washer:
• Do not straighten the drain hose, and do not force excess drain
hose into the standpipe. Hose should be secure, but loose
enough to provide a gap for air.
• When routing the drain hose through cabinets or walls, use a
protective material such as electrical tape to cover sharp edges
that could damage the hose.
Connect the Inlet Hoses
Before connecting any hoses, run the faucets until the water is clear
to remove any debris. Make sure the drum is empty.
1. Connect the angled ends of the hoses to the inlet valves at the
back of the machine (20mm threads). Screw on the couplings
Installation Information
(Continued on the next page)
9