Splendide WD2000S Training Manual page 13

Drain System Requirements
The washer-dryer can be installed using the standpipe drain
system, fl oor drain system or the sink drain system. To prevent
siphoning, the outlet end of the drain hose MUST always be 20"
(50.8 cm) above the base of the machine. Not more than 6" (15.24
cm) of the drain hose should be inserted into the drain pipe.
Floor Standpipe
A
A & B = 25" (62 cm) min. / 34" (86 cm) max.
The standpipe drain requires a minimum diameter standpipe of
1-1/4" (3.2 cm). The minimum carry-away capacity can be no less
than 7 gal (26.5 L) per minute.
The top of the standpipe must be at least 25 in. (62 cm) high and
no higher than 34" (86 cm) from the bottom of the washer.
The fl oor drain system requires a siphon break that may be
purchased separately.
The sink drain system connected to a garbage disposer requires a
"Y" connector (sold separately.
U-Clamp
20" (50 cm) min.
with an air break
Wall Standpipe
B
6" max.
25" (62 cm) min.
34" (86 cm) max.
Sink Drain W/ "Y" Branch Tailpiece
25" (62 cm) min.
with an air break
Cable tie
"Y" Tail Piece
This connection MUST be
before drain trap and at
least 20" (50.8 cm) above
the floor where washer will
be installed.
Floor Standpipe w/ "Y" Branch Tail Piece
Optional
• The Splendide Faucet Adapter Kit,
Part No. 154187104A
• Supplies water from the faucet
and discharges water directly
into the sink.
• Designed for installations where
washer-dryer hookups are not
available.
Installation Information
Laundry Sink Drain
20" (51.8 cm) min.
34" (86 cm) max.
Fig. 7
Faucet Adapter Kit, Part No.
154187104A
(Continued on the next page)
7