Installation Instructions - Splendide WD2100XC Training Manual

Follow these instructions in order to prevent installation errors and to assure proper washer-dryer operation.
Unpacking the washer-dryer
• Carefully remove the packing materials with care
not to damage the drain hose and power cord
that are shipped installed on the machine. Check
that the machine is intact. Report any damage
immediately.
• Position the washer-dryer near the desired
installation position.
WARNING: Plastic bags, styrofoam, nails
and other packaging parts are not children's
toys and can be potentially dangerous.
Destroy the carton and plastic bags after the
washer-dryer has been unpacked.
Removing the transit screws
For transportation, the inside of the machine is supported
by screws, rubber grommets and spacers on the back
panel. Before using the washer-dryer, these items MUST
be removed.
IMPORTANT: Transit screws and spacers must be
removed before operating the machine to allow
proper operation of the machine and to prevent
damage to the appliance.
• After positioning
the washer-dryer
near the installation
location, remove the
four screws (Fig.1),
with the rubber
grommets and plastic
spacers that are
attached to them.
• Use the plastic plugs
(provided in the accessories bag) to fi ll in the holes.
IMPORTANT: Retain the transit screws, spacers and
rubber tubes. These items should be reinstalled to
prevent damage if or when you transport the ma-
chine in the future.

Installation Instructions

Connecting the water inlets
If the water pipes you will be connecting to are
new or unused, run the water until clear to remove
any debris that could clog the water valve screens
or valves before connecting the machine. NOTE:
Supply shut-off valves should be easily accessible.
IMPORTANT: Water pressure MUST
range within the values indicated on the
"Technical Data" chart
• Included in the accessories supplied with
your machine are 2 inlet hoses with 4 rubber
washers pre installed. Check that the rubber
washers are installed in the ends of the inlet
hoses to make a water tight seal at each
connection point.
• Connect the straight ends of the water inlet
hoses to the
supply taps
that have ¾"
BSP thread
(standard hose
bib).
• Connect the
90º angled
ends (20 mm
thread) of
these hoses to
the inlet valves
on the back of the machine (Fig. 2). NOTE:
Water Inlet valves are color coded: Red (Hot) &
White (Cold).
IMPORTANT: Do not use excessive force.
Damage to the couplings can result. The
couplings should be tightened by hand; a
tool should only be used if a leak occurs.
Installation Information
9