Winterization Instructions / Optional Rv Winterization - Splendide WD2000S Training Manual

Right. It should spring back to the Left. If you test a model WD2100 or WD2000S and the Airfl ow
and Heat Test results are normal but the problem persists, check the dryer exhaust system for
obstructions:
• With the dryer ON, check the airfl ow exiting from the vent located on the outside wall and clear
any obstructions.
• Disconnect the fl ex/metal dryer ducting from the back of the machine. With the dryer ON, check
the airfl ow exiting from the back of the machine and clear any obstructions.
Winterization Instructions
To winterize your washer-dryer:
1. With the machine power OFF, pour ½ quart of RV-type antifreeze into the washer drum
2. Close the door. Advance the Program Selector knob to a SPIN position
3. Press ON/OFF Button (IN). Wait 1-2 minutes
4. Press ON/OFF Button (OUT). Unplug the washer-dryer from the electrical outlet (or disconnect
power)
5. Turn the water supply faucets OFF. Disconnect the inlet hoses from the faucets. Drain any remaining
water from the hoses. Finished!
Optional RV Winterization - If you're currently pumping antifreeze through the fresh
water system, follow these steps to winterize:
1. With the machine power OFF, turn the WASH TEMP knob to HOT
2. Advance the Program Selector knob to REGULAR in Cotton Heavy Duty
3. Press the ON/OFF button (IN) and let the machine fi ll until antifreeze is in the drum
4. Advance Program Selector to a RESET. Wait 5 seconds (Status/Door Lock LED will blink)
5. Advance Program Selector to a SPIN position. Let the antifreeze drain from the drum
6. Advance Program Selector to RESET. Wait 5 seconds (Status/Door Lock LED will blink)
7. Turn the WASH TEMP knob to COLD
8. Advance the Program Selector knob to REGULAR in Cotton Heavy Duty
9. Let the machine fi ll until you see antifreeze in the drum
10. Advance the Program Selector knob to RESET. Wait 5 seconds (Status/Door Lock LED will blink)
11. Advance the Program Selector knob to SPIN. Let the antifreeze drain from the drum
12. Press the ON/OFF button (OUT). Finished!
To use again, fl ush the water pipes, then:
1. Reconnect the water inlet hoses to the corresponding HOT/COLD faucets. Turn the faucets ON.
(NOTE: Check the water inlet hoses and pump periodically. Refer to the "Use & Care Guide" that
came with the machine)
2. Plug the washer-dryer into an appropriate electrical outlet (or reconnect power supply)
3. With the ON/OFF button in the off (OUT) position, pour 1/2 TBSP. of powder detergent (or liquid
equiv.) into the 'Detergent' compartment inside the Dispenser Drawer
4. Advance the Program Selector knob to an EXPRESS cycle
5. Press the ON/OFF button (IN) and allow the machine to run through the complete cycle to clean
out any remaining antifreeze. Finished!
61
Tech Tips