Btu & Efficiency Specifications; Non-Combustible Materials; Combustible Materials; Electrical Codes - Quadra-Fire 7100FP-BK-B Owner's Manual

C. BTU & Efficiency Spectifications
EPA# and Original Date:
EPA Certified:
Efficiency:
BTU Output
with EPA test fuel:
with Cord Wood:
Heating Capacity:
Vent Size:
Max Wood Length:
Fuel:
Shipping Weight:
Firebox Size
D. Non-Combustible Materials
• Materials which will not ignite and burn, composed of
any combination of the following:
- Steel - Iron
- Brick - Tile
- Concrete - Slate
- Glass - Plasters
• Materials reported as passing ASTM E 136, Standard
Test Method for Behavior of Metals, in a Vertical Tube
Furnace at 750° C
E. Combustible Materials
• Materials made of or surfaced with any of the following
materials:
- Wood - Compressed paper
- Plant fibers - Plastic
• Any material that can ignite and burn; flame proofed or
not, plastered or un-plastered
F. Electrical Codes
NOTICE: This appliance must be electrically wired
and grounded in accordance with local codes or, in the
absence of local codes, with National Electric Code ANSI/
NFPA 70-latest edition or the Canadian Electric Code
CSA C22.1.
• A 110-120 VAC circuit for this product must be protected
with ground-fault circuit-interrupter protection, in
compliance with the applicable electrical codes, when
it is installed in damp locations.
Electrical Codes are used only if the unit is supplied with
a fan.
4/12
#571 4-1-03
3.1 grams per hour
up to 77%
58,000 / hr.
90,000 / hr.
up to 3,500 sq ft
8 inches
24 inches
Cord Wood
670 lbs
3.7 cubic feet
433-1390K
WARNING! Improper installation, adjustment, altera-
tion, service or maintenance can cause injury or prop-
erty damage. Refer to the owner's information manual
provided with this fireplace. For assistance or additional
information consult a qualified installer, service agency
or your dealer.
G. Glass Specifications
This fireplace is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
NOTICE: This installation must conform with local codes. In
the absence of local codes you must comply with the UL127,
(UM) 84-HUD and NFPA211 in the U.S.A. and the ULC
610-M87 and CAN/CSA-B365 Installation Codes in Canada.
WARNING! Risk of Fire! Hearth & Home Technologies
disclaims any responsibility for, and the warranty and
agency listing will be voided by the following actions.
DO NOT:
• install or operate damaged fireplace
• modify fireplace
• install other than as instructed by Hearth & Home
Technologies
• operate the fireplace without fully assembling all
components
• overfire
• install an unvented gas log set
• install any component not approved by Hearth & Home
Technologies
• install parts or components not Listed or approved
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualified
installer, service agency or your dealer.
Page 7