Olivetti d-COLOR P2021 Operation Manual page 84

>Report
Copies
>Report
Copies
>Report
Delete
>Quick Copy
?Harold
6
Press or
Note If you selected All Files, this process is applied to
all the documents in the Quick Copy/Proof-and-Hold.
7
Press [OK]. The number of copies to be printed can be set. To
increase the copy count, press
001 .
Note If you selected All Files, press
- is displayed to set the number of copies. When using the
number of copies specified with print job, select Copies ---.
8
Press [OK] to finalize the copy count. The printer prints the specified
number of copies for the job.
Deleting a Quick Copy Job
1
Follow steps 1 through 6 in the above section to let the title of the job
to be deleted displayed.
2
When the title of the job to be deleted is displayed, e.g. Report,
press [OK]. The cursor (_) below the copy count starts to blink.
001
3
Press repeatedly until Delete appears below the title.
Note If you selected All Files, this process is applied to
all the documents in the Quick Copy/Proof-and-Hold.
4
Press [OK]. The message Processing appears and the stored
quick copy job is deleted.
Using Proof-and-Hold
When you print multiple copies, this mode first prints one copy so that you
can proof it before continuing to print the remaining copies. Since you can
proof the printouts before printing the remaining copies, wastage of paper
can be reduced.
The printer prints one copy and, at the same time, saves the print job on
the hard disk/RAM disk. You can also change the number of copies when
resuming printing from the operation panel.
When the printer is turned off, all stored jobs will be deleted.
Note Refer to Printing System Driver User Guide for the driver
settings.
Printing Remaining Copies of a Proof-and-Hold Job
1
Press while Job Box > is displayed.
2
Press or
entered in the printing system driver (Harold, in this example) also
appears.
3
Press [OK]. A blinking question mark (?) appears before the user
name.
4-24
to scroll to the desired job title.
; to decrease the copy count, press
repeatedly until >Quick Copy appears. The name
Using the Operation Panel
after Copies --