Hookup; Rear-Panel Connections And Controls; Inputs - PRESONUS Temblor T10 Owner's Manual

2

Hookup

2.1

Rear-Panel Connections and Controls

2 Hookup
2.1 Rear-Panel Connections and Controls

2.1.1 Inputs

2
[+]
XLR
Line-level Inputs: The Temblor T10 provides a choice of
three input pairs: two sets of balanced inputs (XLR and
¼" TRS) and one pair of RCA unbalanced inputs. When
both of the balanced connections are in use, the TRS
inputs will take precedence over the XLR inputs. The
RCA inputs will sum into either balanced connection.
Two inputs are provided in order to accept a stereo
signal from the output of your audio source. Both
channels should be connected, as they will be summed
together before passing through the onboard lowpass
filter, so you do not have to connect your audio source to
a crossover.
1
Ground
3
[-]
Power User Tip: If your audio source provides balanced XLR
or ¼" TRS (tip-ring-sleeve) outputs, use the corresponding
balanced Temblor inputs. Balanced connections are resistant
to induced noise from radio-frequency or electromagnetic
interference (RFI or EMI). If the audio source has unbalanced
¼" TS (tip-sleeve) outputs, use ¼"-to-RCA adapters or
adapter cables. Always use the shortest cables possible
to minimize the risk of induced RFI or EMI noise.
Input Gain: Sets the level of the input signal before it is
amplified.
Sleeve:
Ground
TRS
Temblor T10
Owner's Manual
Ring: Tip:
[-] [+]
3