Table of Contents
Advertisement
2
Hookup
2.1
Rear-Panel Connections and Controls
Hookup
2
Rear-Panel Connections and Controls
2.1
2.1.1
Inputs
2.1.2
Outputs
2.1.3
Power
Line-level Inputs. The Eris Pro Sub 10 provides a choice of three input pairs: two sets
of balanced inputs (XLR and ¼" TRS) and one pair of RCA unbalanced inputs. When
both of the balanced connections are in use, the TRS inputs will take precedence
over the XLR inputs. The RCA inputs will sum into either balanced connection.
Power User Tip: Connect both the left and right inputs if you are using the
onboard crossover in your Eris Pro Sub 10 to connect your full-range monitors or
if you're running your Pro Sub 10 independently from a stereo source (such as the
Monitor Station or Central Station). This will ensure that your Pro Sub 10 receives
the low-frequency content from both channels. If your audio source provides
a mono or LFE output, you only need to connect one input—either L or R.
2
1
[+]
Ground
3
[-]
XLR
TRS
Input Gain. Sets the level of the input signal before it is amplified.
Outputs. The Eris Pro Sub 10 provides two pairs of outputs: XLR
and ¼" TRS. The full-range signal connected to the stereo inputs
on the T10 is passed through to these outputs. Use these outputs
to connect your main left and right studio monitors.
If the High Pass Filter switch is engaged, frequencies below 80 Hz are not sent
from these outputs.
Sub Out: This XLR Output sends the summed full-range input signal to a second Eris
Pro Sub 10. When connecting a second Pro Sub 10 to this output, set its Low Pass
Filter control to the same setting as the first.
IEC Power Connection. Your Eris Pro Sub 10 accepts a standard IEC power cord.
Warning: Do not remove the center grounding prong or use a separate
ground-lift adapter, as this could result in electric shock.
Power Switch. This is the On/Off switch. The power status is indicated by the
illuminated logo on the front of the cabinet.
AC Select Switch. The input-power voltage is set at the factory to correspond
with the country to which it was shipped. Use this switch only if you are
using your Eris Pro Sub 10 in a country that uses a different standard voltage
than is used in the country where you purchased your Pro Sub 10.
Sleeve:
Ring:
Tip:
Ground
[-]
[+]
Eris
Pro Sub 10
®
Owner's Manual
4
Advertisement
Table of Contents
