PRESONUS Temblor T10 Owner's Manual page 15

3 Tutorials
2.2 Hookup Diagrams
0
GND
Polarity
GND
7. Pan the pink noise so that it only plays in the
right speaker (hard right), and repeat step 6 for
the right channel.
8. Turn your full-range monitors off.
SPL:
79 dB
10. Set the lowpass filter on your T10 to 130 Hz. This
will create an overlap between your T10's and
your full-range system's frequency responses.
9. Begin slowly increasing the input
volume on your Temblor T10 until
the acoustic level of the pink
noise reaches 79 dB SPL on your
SPL meter when measured at
mix position.
Temblor T10
Owner's Manual
13