Outputs; Power - PRESONUS Temblor T10 Owner's Manual

2 Hookup
2.1 Rear-Panel Connections and Controls

2.1.2 Outputs

2.1.3 Power

Outputs: The Temblor T10 provides two pairs
of balanced outputs: XLR and ¼" TRS. The full-
range signal connected to the stereo inputs
on the T10 is passed through to these outputs.
Use these outputs to connect your main left
and right studio monitors. If the High Pass Filter
switch is engaged, frequencies below 80 Hz are
not sent from these outputs.
Sub Out: This balanced XLR output sends the low-frequency
signal from the lowpass filter to a second Temblor T10. When
connecting a second T10 to this output, set its Low Pass Filter
control to its highest setting.
IEC Power Connection: Your Temblor T10 accepts a standard
IEC power cord.
Warning: Do not remove the center grounding prong or use a
separate ground-lift adapter, as this could result in electric shock.
Power Switch: This is the On/Off switch. The power status is
indicated by the illuminated logo on the front of the cabinet.
AC Select Switch: The input-power voltage is set at the factory
to correspond with the country to which it was shipped. Use
this switch only if you are using your Temblor T10 in a country
that uses a different standard voltage than is used in the
country where you purchased your T10.
Temblor T10
Owner's Manual
4