Toyota Sienna 2001 Operating Manual page 36

Table of Contents

Advertisement

WHEN THE SYSTEM IS SET
Activating the system
The system will give the alarm under the
following conditions:
D
If any of the front, sliding or back
doors is unlocked or if the hood is
forcibly opened without the key or wire-
less remote control transmitter
D
If the battery terminal is disconnected
and then reconnected
The indicator light will come on when the
system is activating.
If any of the doors is unlocked without the
key or wireless remote control transmitter
and the key is not in the ignition switch,
all the doors will be automatically locked
again.
After 1 minute, the alarm will automatically
stop and the indicator light will start flash-
ing again.
Reactivating the alarm
Once set, the system cannot be cancelled
without the key or wireless remote control
transmitter. If the front, sliding and back
doors and hood are closed after the alarm
stops, the system automatically resets the
alarm.
36
01 SIENNA_U (L/O0008)
The alarm will activate again under the
same
circumstances
described
"Activating the system".
Stopping the alarm
To stop alarm midway, do the following:
D
Unlock either front door or back door
with the key or wireless remote control
transmitter.
D
Turn the key from the "LOCK" to "ON"
position.
These ways cancel the system at the
same time.
TESTING THE SYSTEM
1. Open all the windows.
2. Set the system as described above.
The doors should be locked with the
key or wireless remote control transmit-
ter. Be sure to wait until the indicator
light goes off or starts flashing.
3. Unlock any door from the inside. The
system should activate the alarm.
4. Cancel the system as described above.
5. Repeat this operation for the other
doors and hood. When testing on the
hood, also check that the system is
activated when the battery terminal is
disconnected and then reconnected.
2001 MY SIENNA (OM45406U)
If the system does not work properly,
in
have it checked by your Toyota dealer.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents