Toyota Sienna 2001 Operating Manual page 23

RESETTING THE POWER SLIDING
DOOR SYSTEM
If the power sliding door system operates
incorrectly or does not operate under the
following conditions, the system must be
initialized and reset by the steps in the
next column.
D
The battery is disconnected and then
reconnected, or a discharged battery is
recharged.
In this case, initialize and reset the
system by doing the following steps
from 6 to 10.
D
The open power sliding door warning
light stays on though the sliding door
is closed.
In this case, initialize and reset the
system by doing the following steps
from 1 to 10.
CAUTION
To initialize and reset power sliding
door system, stop the vehicle on a
level ground.
01 SIENNA_U (L/O0008)
1. Be sure to turn off the power sliding
door system by pushing in the "PWR
DOOR OFF" switch.
2. Disconnect the battery for 1 minute
and then reconnect it.
3. Close the sliding door by hand.
(Step 3 can be performed before step
2.)
4. Turn on the power sliding door system
by pushing out the "PWR DOOR OFF"
switch.
5. Wait 5 seconds.
6. Open the sliding door by using one of
the "DOOR L", "DOOR R" and "PWR
DOOR" switches.
7. Wait 3 seconds after the sliding door
stops at the fully–opened position.
8. Close the sliding door by using one of
the "DOOR L", "DOOR R" and "PWR
DOOR" switches inside the vehicle or
"POWER DOOR", "D–PWR DOOR" and
"P–PWR DOOR" switches of the wire-
less remote control transmitter.
9. Wait 3 seconds after the sliding door
stops at the fully–closed position.
10. Repeat the steps from 6 to 9.
2001 MY SIENNA (OM45406U)
If the power sliding door system does not
operate properly after the above proce-
dure, there may be a problem in the sys-
tem. Contact your Toyota dealer.
23