Toyota Sienna 2001 Operating Manual page 20

Instrument panel
Center pillar
20
01 SIENNA_U (L/O0008)
"DOOR L", "DOOR R" AND "POWER
DOOR" SWITCHES
These switches are used to open and
close the power sliding door. Push and
release one of the "DOOR L", "DOOR
R" and "PWR DOOR" switches.
Opening and closing can be performed by
the "DOOR L", "DOOR R" and "PWR
DOOR" switches under the following con-
ditions:
D
The sliding door is unlocked.
D
The power sliding door system is on.
(The "PWR DOOR OFF" switch is
pushed out.)
D
To open the power sliding door when
the ignition key is in the "ON" position,
the transmission selector lever must be
in "P". (To close the sliding door from
the fully–opened or half–opened posi-
tion, the transmission selector lever is
not required to be in "P".)
Left and right side power sliding door
models—The left side power sliding door
does not operate when the fuel filler door
is opened.
2001 MY SIENNA (OM45406U)
CAUTION
If you shift the automatic transmis-
sion selector lever out of "P" and
accelerate before the power sliding
door is closed completely, the sliding
door may reverse to the open posi-
tion. A child or others could fall out
of the vehicle and be injured. Always
make sure the power sliding door is
closed and latched before you start
driving.
OPENING BY HAND
When the power sliding door system is
on, if you pull the outside door handle or
push the inside lock release button to re-
lease the sliding door, it will then automat-
ically and completely open.
When the power sliding door system is
off, open the sliding door as usual.
CLOSING BY HAND
When the power sliding door system is
on, if you slide the door about 10 cm (4
in.) to the closing direction and let the
door go, it will automatically and com-
pletely close.
When the power sliding door system is
off, close the sliding door as usual.