Canon LBP3460 User Manual page 236

<18 FEED ERROR>
Cause Paper of the size or type that cannot be fed from the multi-purpose tray or paper
cassette is specified.
Remedy 1 If a paper source is specified, press [Select Feeder], then set PAPER SOURCE
to AUTO.
Remedy 2 Press [Select Feeder], select a paper source from which paper of the specified
size or type can be fed, then load paper.
Remedy 3 Specify the settings for STD PAPER SIZE and STD PAPER TYPE in the
FEEDER MENU options in the SETUP menu to the size or type of paper that
can be loaded in the paper source.
Remedy 4 Press [Online], then print from the currently selected paper source. However,
this may result in deterioration in print quality.
<1G CHECK TONER>
Cause The toner cartridge has reached the end of its life.
Remedy Take the toner cartridge out of the printer and replace it with a new one. (See
"Replacing the Toner Cartridge," on p. 6-2)
<1H CHK TNR CONN.>
Cause There is a possibility that the toner cartridge is not installed properly.
Remedy 1 Remove the toner cartridge, then reinstall it properly.
Remedy 2 If <1H CHK TNR CONN.> appears and there is a problem with the print quality
even after applying the Remedy 1, remove the toner cartridge and replace it
with a new one. (See "Replacing the Toner Cartridge," on p. 6-2)
<23 DOWN.MEM.FULL>
Cause The memory for registering overlay forms and custom characters has run out
and overflowed.
Remedy 1 The printer continues printing by pressing [Online]. However, the overflowed
data cannot be registered.
Remedy 2 Perform a soft reset using the RESET menu, increase the free space of RAM
using the following procedure, register the data again, and then print again.
•
Perform a hard reset or cycle the power of the printer (Be aware that all the
data in the memory will be deleted).
•
Install an optional expansion RAM module. (See Getting Started Guide)
(Warning Message)
(Warning Message)
<Error Skip>
Message List 7-25
7