Toshiba BU406M Instruction Manual page 53

● Setting
- Set the width of Timer0Active pulse
Set the following value to "TimerDuration" register. Setting value is Float type.
- Set the delay of Timer0Active pulse
Set the following value to "TimerDelay" register. Setting value is Float type.
- Select the source of Timer0Active pulse to start
Select the following value to "TimerTriggerSource" register. Setting value is Enumeration type.
TimerTriggerSource
● Note
"TimerTriggerSource" operation is as follows,
Line0Active is available in
FrameTrigger is available in both
FrameTriggerError.
ExposureStart is available in both
Timer0Active pulse delays TiggerDelay+TimerDelay[us].
FrameTriggerError.
Copyright © 2013 TOSHIBA TELI CORPORATION, All rights reserved.
TimerDuration
Minimun (*)
Maximum
TimerDelay
Minimun (*)
Maximum
Off Disables the timer trigger.
Line0Active Starts when TRIG_IN (Line0) is active.
ExposureStart (*) Starts with the reception of the Exposure Start
FrameTrigger Starts with the reception of the Frame Start Trigger.
HardwareTrigger mode, and to be responsed at FrameTriggerError.
HardwareTrigger and Software Trigger mode, and not to be responsed at
HardwareTrigger and Software Trigger mode, and not to be responsed at
Pulse width
0.00[µs]
4095.00[µs]
* initial factory setting
Delay value
0.00[µs]
4095.00[µs]
* initial factory setting
Description
* initial factory setting
52 / 65
D4223121B
www.toshiba-teli.co.jp