- Select the polarity of each signal
Set the following value to "LineInverterAll" register. The setting value is Integer type.
Each bit corresponds to each Line. Both Line0 and Line1 are settable.
Inverter is also inserted to UserOutputValue.
● Note
About the details of Timer0Active signal, refer to "TimerControl" of "Functions".
Copyright © 2013 TOSHIBA TELI CORPORATION, All rights reserved.
LineInverterAll
0 (*)
non inverted
1
* initial factory setting
Fig. GPIO internal circuit diagram
50 / 65
Function
inverted
D4223121B
www.toshiba-teli.co.jp