Table of Contents
Advertisement
● Setting
- Select the Line of the I/O connector
Set the following value to "LineSelector" register. Select the line to output "LineSource" signal.
Setting value is Enumeration type.
LineSelector
Line1 (*)
Line2
- Select the source of GPIO output signal
Set the following value to "LineSource" register to change GPIO output signal selected by "LineSelector".
Setting value is Enumeration type.
LineSource
Off (*)
FrameTriggerWait
FrameActive
FrameTransfer
ExposureActive
UserOutput
Timer0Active
- Set the UserOutput signal
Set the following value to "UserOutputValueAll" register. Setting value is Integer type.
Each bit corresponds to each Line (bit0=Line0, bit1=Line1).
Line1 and Line2 are available. Line0 is dedicated trigger input.
Copyright © 2013 TOSHIBA TELI CORPORATION, All rights reserved.
I/O connector pin assignment
2 pin: GPIO Output
1 pin: GPIO Output
No output.
Indicating waiting a Random Trigger Shutter.
An External trigger is input during this period, exposure starts immediately.
Period from exposure start to CMOS sensor read-out completion.
Period of transferring image data on USB bus.
Period from exposure start to exposure end.
Outputs the value set in "UserOutputValueAll".
This signal can be used as strobe control signal.
The delay time and pulse width from source signal are configurable.
UserOutputValueAll
0 (*)
1
LineMode
Output
5V CMOS
Output
5V CMOS
Signal description
Function
Low level output
High level output
* initial factory setting
49 / 65
Output circuit
* initial factory setting
* initial factory setting
D4223121B
www.toshiba-teli.co.jp
Advertisement
Table of Contents
