Table of Contents
Advertisement
Gain
This section describes Gain control of LuminanceControl category.
This control adjusts the gain of the image.
● Registers
Register
Gain
● Setting
- Set Manual Gain
Set the following value to "Gain" register. Setting value is Float type. This setting value is valid only at
Manual Gain mode setting.
The formula of Gain value is as follows;
● Note
Notes on gain setting:
Setting the gain value too high increases noises. When you adjust the brightness of the image, I ask you to have final
image quality checked with your environment.
Copyright © 2013 TOSHIBA TELI CORPORATION, All rights reserved.
Visibility
Access
Beginner
R/W
Sets the Gain.
Gain
Minimum (*)
Maximum
Output signal = Input signal x Gain
Fig. Gain
Description
Value
x0.00 [times]
x8.00 [times]
* initial factory setting
40 / 65
D4223121B
www.toshiba-teli.co.jp
Advertisement
Table of Contents
