Error Message About Reading Usb Drive Appears; Jobs Do Not Print - Lexmark W850 User Manual

Troubleshooting

Error message about reading USB drive appears

Make sure the USB drive is supported. For information regarding tested and approved USB flash memory devices, see
"Printing from a flash drive" on page 72.

Jobs do not print

These are possible solutions. Try one or more of the following:
M
AKE SURE THE PRINTER IS READY TO PRINT
Make sure Ready or Power Saver appears on the display before sending a job to print.
C
HECK TO SEE IF THE STANDARD EXIT BIN IS FULL
Remove the stack of paper from the standard exit bin.
C
HECK TO SEE IF THE PAPER TRAY IS EMPTY
Load paper in the tray.
M
AKE SURE THE CORRECT PRINTER SOFTWARE IS INSTALLED
•
Verify that you are using the correct printer software.
•
If you are using a USB port, make sure you are running a supported operating system and using compatible printer
software.
M
AKE SURE THE INTERNAL PRINT SERVER IS INSTALLED PROPERLY AND WORKING
•
Make sure the internal print server is properly installed and that the printer is connected to the network.
• Print a network setup page and check that the status shows Connected. If the status is Not Connected, check the
network cables, and then try printing the network setup page again. Contact your system support person to make
sure the network is functioning correctly.
Copies of the printer software are also available on the Lexmark Web site at www.lexmark.com.
M
AKE SURE YOU ARE USING A RECOMMENDED
For more information, visit the Lexmark Web site at www.lexmark.com.
M
AKE SURE PRINTER CABLES ARE SECURELY CONNECTED
Check the cable connections to the printer and print server to make sure they are secure.
For more information, see the setup documentation that came with the printer.
USB, , E
SERIAL OR THERNET CABLE
177