Too Many Disks Installed; Too Many Flash Options Installed; Defective Disk - Lexmark W850 User Manual

Troubleshooting
57 Configuration change, some held jobs were not restored
Since the time the jobs were stored on the printer hard disk, something changed in the printer to invalidate the held
jobs. Possible changes include:
• The printer firmware was updated.
•
Paper input, output, or duplex options needed for the print job were removed.
•
The print job was created using data from a device in the USB port, and the device is no longer in the port.
•
The printer hard disk contains jobs that were stored while installed in a different printer model.
Press the up or down arrow button until Continue appears, and then press

58 Too many disks installed

1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove the extra disks.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.

58 Too many flash options installed

Too many optional flash memory cards or too many optional firmware cards are installed on the printer.
Try one or more of the following:
•
Press the up or down arrow button until Continue appears, and then press
continue printing.
• Remove extra flash options:
1
Turn the printer off.
2
Unplug the power cord from the wall outlet.
3
Remove extra flash options.
4
Connect the power cord to a properly grounded outlet.
5
Turn the printer back on.

61 Defective disk

Install a different hard disk before performing any operations that require a hard disk.
to clear the message.
to clear the message and
150