Honda 2003 ST1300lA Owner's Manual page 160

Installation
1. Reassemble the removed parts in the reverse order of removal.
2. Tighten the rear wheel nuts to the specified torque:
80 lbf.ft (108 N.m
Tighten the rear caliper stopper bolt to the specified torque:
51 lbf.ft (69 N.m ,7.0 kgf.m)
3. After installing the wheel, apply the brake several times and then check if the
wheel rotates freely. Recheck the wheel if the brake drags or if the wheel
does not rotate freely.
4. Operate the brake pedal and check the brake operation.
5. Inspect the brake system (page 123
If a torque wrench was not used for installation, see your Honda dealer as
soon as possible to verify proper assembly. Improper assembly may lead to
loss of braking capability.
If You Have a Flat Tire
,
11.0 kgf.m)
).
Taking Care of the Unexpected
protective tape
159