Install The Switch; Desktop Installation - Planet XGSW-28040 User Manual

■ AC Power Receptacle
For compatibility with electric service in most areas of the world, the Managed Switch's power supply automatically adjusts
to line power in the range 100-240VAC and 50/60 Hz.
Plug the female end of the power cord firmly into the receptalbe on the rear panel of the Managed Switch. Plug the other
end of the power cord into an electric service outlet then the power will be ready.
The device is a power-required device, it means, it will not work till it is powered. If your networks should
active all the time, please consider using UPS (Uninterrupted Power Supply) for your device. It will
prevent you from network data loss or network downtime.
Power Notice:
In some area, installing a surge suppression device may also help to protect your Managed Switch from
being damaged by unregulated surge or current to the Switch or the power adapter.
■ SFP+ slots
10GBase-SR/LR slot, SFP+ (Enchanced Small Factor Pluggable) transceiver module: From 550 meters (Multi-mode fiber),
up to 10kilometers (Single-mode fiber).
The SFP+ slot supports 1000Baase-SX/LX/BX too. 1000Base-SX/LX/BX mini-GBIC slot, SFP (Small
Factor Pluggable) transceiver module: From 550 meters (Multi-mode fiber), up to 10/30/50/70/120
kilometers (Single-mode fiber).

2.2 Install the Switch

This section describes how to install your Managed Switch and make connections to the Managed Switch. Please read the
following topics and perform the procedures in the order being presented. To install your Managed Switch on a desktop or shelf,
simply complete the following steps.

2.2.1 Desktop Installation

To install the Managed Switch on desktop or shelf, please follows these steps:
Attach the rubber feet to the recessed areas on the bottom of the Managed Switch.
Step1:
Place the Managed Switch on the desktop or the shelf near an AC power source, as shown in
Step2:
32
User's Manual of XGSW-28040
Figure 2-5.