Dynamic Ip Source Guard Table - Planet XGSW-28040 User Manual


Port

VLAN ID

MAC Address

IP Address
Buttons
Auto-refresh : Check this box to refresh the page automatically. Automatic refresh occurs every 3 seconds.
: Refreshes the displayed table starting from the "Start from MAC address" and "VLAN" input fields.
: Flushes all dynamic entries.
: Updates the table starting from the first entry in the MAC Table, i.e. the entry with the lowest VLAN ID and MAC
address.
: Updates the table, starting with the entry after the last entry currently displayed.

4.13.4 Dynamic IP Source Guard Table

Entries in the Dynamic IP Source Guard Table are shown on this page. The Dynamic IP Source Guard Table is sorted first by
port, then by VLAN ID, then by IP address, and then by IP mask. The Dynamic IP Source Guard Table screen in
appears.
Navigating the ARP Inspection Table
Each page shows up to 99 entries from the Dynamic IP Source Guard table, default being 20, selected through the "entries per
page" input field. When first visited, the web page will show the first 20 entries from the beginning of the Dynamic IP Source
Guard Table.
The "Start from port address", "VLAN", "IP address" and "IP mask" input fields allow the user to select the starting point in the
Dynamic IP Source Guard Table. Clicking the "Refresh" button will update the displayed table starting from that or the closest
next Dynamic IP Source Guard Table match. In addition, the two input fields will - upon a "Refresh" button click - assume the
value of the first displayed entry, allowing for continuous refresh with the same start address.
The port number for which the status applies. Click the port number to see the
status for this particular port.
The VLAN ID of the entry.
The MAC address of the entry.
The IP address of the entry.
Figure 4-13-4 Dynamic IP Source Guard Table screenshot
288
User's Manual of XGSW-28040
Figure 4-13-4