Planet XGSW-28040 User Manual page 36
24-port gigabit with 4 shared sfp 4-port 10g sfp+ managed switch
Hide thumbs
Also See for XGSW-28040:
- Quick installation manual (12 pages) ,
- Command manual (433 pages)
Table of Contents
Advertisement
MGB-LA40
MGB-LB40
Fast Ethernet SFP Transceiver modules
MFB-FX
MFB-F20
MFB-F60
MFB-FA20
MFB-FB20
1.
2.
3.
Before connect the other Managed Switches, workstation or Media Converter.
In the installation steps below, this Manual use Gigabit SFP transceiver as the example. However,
the steps for Fast Ethernet SFP & 10G SFP+ transceiver are similar.
1.
Make sure both side of the SFP transceiver are with the same media type, for example: 1000Base-SX to 1000Base-SX,
1000Bas-LX to 1000Base-LX.
2.
Check the fiber-optic cable type match the SFP transceiver model.
To connect to 1000Base-SX SFP transceiver, use the Multi-mode fiber cable- with one side must be male duplex LC
connector type.
To connect to 1000Base-LX SFP transceiver, use the Single-mode fiber cable-with one side must be male duplex LC
connector type.
Connect the fiber cable
1.
Attach the duplex LC connector on the network cable into the SFP transceiver.
2.
Connect the other end of the cable to a device – switches with SFP installed, fiber NIC on a workstation or a Media
Converter..
3.
Check the LNK/ACT LED of the SFP slot on the front of the Managed Switch. Ensure that the SFP transceiver is operating
correctly.
4.
Check the Link mode of the SFP port if the link failed. Co works with some fiber-NICs or Media Converters, set the Link
mode to "1000 Force" or "100 Force" is needed.
Remove the transceiver module
1.
Make sure there is no network activity by consult or check with the network administrator. Or through the management
SFP-Port 1000Base-LX (WDM,TX:1310nm) -40KM
SFP-Port 1000Base-LX (WDM,TX:1550nm) -40KM
SFP-Port 100Base-FX Transceiver -2KM
SFP-Port 100Base-FX Transceiver -20KM
SFP-Port 100Base-FX Transceiver -60KM
SFP-Port 100Base-BX Transceiver (WDM,TX:1310nm) -20KM
SFP-Port 100Base-BX Transceiver (WDM,TX:1550nm) -20KM
It recommends using PLANET SFP / SFP+s on the Managed Switch. If you insert a SFP / SFP+
transceiver that is not supported, the Managed Switch will not recognize it.
Port 25 to Port 28 are SFP+ slots that support 10G SFP+ transceiver & Gigabit SFP transceiver.
Port 22 to Port 24 are shared SFP slot that support Gigabit & Fast Ethernet SFP transceiver.
36
User's Manual of XGSW-28040
Advertisement
Table of Contents
