Threading The Upper Thread - Husqvarna Quilt Designer II User Manual

Threading the Upper Thread

When threading the upper thread, make sure that
the presser foot is raised and the needle is in the up
position. The threading differs de pend ing on which
spool pin position you choose.
Horizontal Spool Pin
1. Pull the spool pin out. Place the spool on the
spool pin (follow the instuctions on previous
page). The thread shall reel counter-clockwise.
Push the spool pin back in.
Hold the thread near the spool using your right
hand. Use your left hand to bring the end of the
thread in the direction of the arrow.
2. Bring the thread up and over the pre-tension
thread gui de (a) and under the thread guide (b).
Bring the thread over the thread ten sion discs (c).
3. Continue threading in the direction indicated by
the arrows. Bring the thread from the right when
threading into the slot on the take-up lever.
4. Pull the thread into the last guide just above the
needle.
Vertical Spool Pin
1. Pull the spool pin out. Place the spool on the
spool pin following the instructions on previous
page (Vertical Position).
2. Thread the machine according to the instructions
above with one exception. Instead of bringing the
thread up and over the pre-tension guide, bring it
directly across and into the thread guide (b).
Learn your Quilt Designer II
Threading when using horizontal spool pin
Threading when using vertical spool pin.
b
a
c
3.
2.
4.
b
1.
9