Function Buttons - Husqvarna Quilt Designer II User Manual

Function Buttons

Stitch Re-start is used to start sew ing your
se lect ed stitch at the beginning of the stitch,
with out hav ing to re-set any spe cial settings
you have made.
STOP is used to conclude a stitch. Your Quilt
Designer II fastens the thread and stops
au to mat i cal ly when a stitch sequence has
been completed. STOP is cancelled when you
touch the button again or by selecting a new
stitch. When STOP is ac tive, the but ton lights
up. The STOP function can be programmed.
It can also be used for one color embroidery.
FIX is automatically activated when a stitch is
se lect ed or when the Selective Thread Cut ter
has been used. FIX is used to tie off stitches.
The button lights up while the FIX function
is active. By touch ing the light ed button the
function can be turned off. When beginning
to sew, Quilt Designer II sews a few tie
off stitch es and goes on with the selected
stitch. Touch FIX while sewing and Quilt
Designer II sews a few tie off stitch es and
stops au to mat i cal ly. The FIX function can be
programmed.
Reverse is pressed to sew in reverse. The
but ton lights up. When the but ton is re leased,
the light goes out and Quilt Designer II sews
forwards. The long est re verse stitch length is
3 mm.
For permanent reverse, touch the button
twice in quick succession before starting to
sew. The button will be lit up and the Quilt
Designer II sews in reverse until you touch
the button again.
Needle stop up/down is used to move the
nee dle down or up and/or to set the nee dle
stop position up or down.
Touch + SPEED or - SPEED to increase or
de crease the sewing speed. If touched when
not sewing, a Pop-up menu on the Touch
Screen in di cates the speed set ting. Touch OK
or start sewing and the Pop-up goes out. You
can change the speed setting while sewing
but no Pop-up will appear.
All stitches in Quilt Designer II have a pre-
set, rec om mend ed sewing speed. When you
select a stitch Quilt Designer II automatically
sets the correct sewing speed.
12
Learn your Quilt Designer II
START/STOP is touched when you want to
run and stop the machine with out
using the foot control. Touch START/STOP to
be gin and touch it again to stop sew ing.
Thread Cutter is touched to cut the top and
bob bin threads. If touched when the machine
is not sew ing, the threads are cut in the
beginning of the following stitch. If the button
is touched while sewing, the "STOP" button
starts fl ash ing and the threads are cut at the
end of the current stitch. When the threads
are cut, the presser foot and the needle are
raised to the up position and the FIX func tion
is activated. The Thread Cutter function can
be programmed
Sensor Foot Lift and Extra Lift is used when
you want the press er foot and the needle to
be lifted to up po si tion. Touch the but ton
once more and the presser foot will raise to
ex tra lift, to make it easy to get thick fab ric
un der the presser foot. See page 13.
Sensor Foot Pivot is used to sim pli fy plac ing
the fabric. Touch this but ton and the press er
foot will be low ered to piv ot po si tion. See
page 13.
Sensor Foot Down is touched when you want
the presser foot to be com plete ly low ered.
Quilt Designer II is fi rm ly hold ing your work,
ready to sew. See page 13.