Appliqué - Husqvarna Quilt Designer II User Manual

Appliqué
Use the preprogrammed sa tin stitches on Stitch d-
Card A to sew appliqués. The pre-programmed sat in
1
stitch es have a stitch width of 2 mm (A
(A 28), and 6 mm (A 29). The top ten sion is re duced
1 1
automatically.
Fabric: Woven medium fabric, Husqvarna Viking
Tear-A-Way stabilizer, Cotton scrap for applique.
Thread: Sulky Rayon embroidery thread on top and
embroidery weight bobbin thread.
Touch: Woven medium on the Sewing Advisor and
stitch A 28 on Stitch d-Card A
1
Use: Presser foot B as recommended.
Sew:
• Cut a small square for the appliqué from the cotton
scrap.
• To baste the applique square to the fabric, touch
A 11 to zigzag stitch or use fusible web.
1
• Place Tear-A-Way stabilizer under the fabric.
• Place the fabric under the presser foot.
• Satin stitch around the square with the outside
swing of the needle sewing off the edge of the
applique.
• To turn outside corners, touch needle stop down
or tap the needle down with the foot control
to pivot with the needle on the outside of the
applique. The Sensor Foot Lift pivot position
makes it easy!
• Touch to secure the stitches.
Note: To adjust the satin stitch length or width, touch
. Use the and
stitch length or width.
The trans par ent press er foot B is an optional
accessory. There is also an open toe appliqué
foot that is com plete ly open in front for great er
vis i bil i ty. Like the trans par ent press er foot B it
fea tures a red guide line for sat in stitching.
60
Decorative Sewing
27), 4 mm
1
.
1
but tons to fi ne tune the