System Reset; Timer Setup; Sleep Timer; Event Timer - Silvercrest KH 2159 Operating Manual

System reset

Via this function you can reset the URC to its factory default
settings. Thereby all settings made by you will be deleted.
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2. With the  or  button t select "SYSTEM SETUP" and
confirm with the OK button l.
3. With the  or  button t select "SYSTEM RESET" and
confirm with the OK button l.
4. In the LCD display q now appears "CONFIRM RESET".
Confirm the reset with the OK button l. Then the LCD
display q shows "SUCCESS RESET". All settings are
now deleted and the menu is closed. Otherwise you can
exit the menu by pressing the EXIT button y. Then the set-
tings remain preserved.

Timer Setup

The URC offers 2 timer modes, sleep timer and event timer.

Sleep timer

1. Press the device button e for the device that is to be con-
trolled (i.e. VCR).
2. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
3. Press the  or  button t until "TIMER SETUP" is
shown. Press the OK button l "TIMER SLEEP" appears in
the LCD display q. Confirm the selection of this function
with the OK button l.
4. Now, below to the right in the LCD display q blinks the
minutes for the remaining time of the selected device.
Set with the  or  button t the desired value from 1
to 99 minutes. Press the OK button l to confirm. With
programmed sleep-timer the LCD display q shows "
on the right next to the time.
5. Position the remote control in such a way that your infra-
red signal can reach the device to be switched off. After
expiration of the set time the remote control will switch the
device off.
6. If you now press the S button r "SL" is shown in the dis-
play q below on the left.

Event timer

The remote control has 4 event timers available via which
you are allowed to send out specific series of button combi-
nations at designated times.
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2. With the  or  button t select "TIMER SETUP" and
confirm with the OK button l. "TIMER SLEEP" appears
in the LCD display q. With the  or  button t select
the desired memory slot "TIMER SETUP 1" to "TIMER
SETUP 4" and confirm with the OK button l.
- 17 -
z "
z