System Reset; Timer Setup; Sleep Timer - Silvercrest SFB 10.1 A1 Operating Manual

4. With the  or  button t now select between „LOCK"
(Block) or „UNLOCK" (Unblock).
5. With the OK button l you save the setting. In the LCD
display q „LOCK SETUP" then appears again.

System reset

With this function you can delete the assignment of all or in-
dividual device buttons.
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2. With the  or  button t select "SYSTEM SETUP" and
confirm with the OK button l.
3. With the  or  button t select "SYSTEM RESET" and
confirm with the OK button l.
4. With the  or  buttons t you can now select the
desired function. To delete the assignments (Code) of all
device buttons e, as well as all data to macros, timer and
learned functions, select "ALL RESET" and confirm it with
the OK button l.
5. In the LCD display q there now appears "CONFIRM
RESET". Confirm the deletion with the OK button l.
Then the LCD display q shows "SUCCESS RESET". The
detailed information is now deleted and the menu is termi-
nated.
6. To delete only the assignments of individual device keys e,
select "MODE RESET" and then press the OK button l.
The LCD display q now shows MODE" and asks you to
press the device button e whose assignment you want to
delete. To conclude, "SUCCESS" briefly appears, then you
will again read "MODE" in the LCD display. Now press
any other further desired device buttons e to also delete
their assignment.
7. Otherwise, you can exit the menu by pressing the EXIT
button y.
Timer Setup
The URC offers 2 timer modes, sleep timer and event timer.

Sleep timer

1. Press the device button e for the device that is to be con-
trolled (i.e. VCR).
2. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
3. Press the  or  button t until "TIMER SETUP" is
shown. Press the OK button l "TIMER SLEEP" appears in
the LCD display q. Confirm the selection of this function
with the OK button l.
4. Now, below to the right in the LCD display q blinks the
minutes for the remaining time of the selected device.
Set with the  or  button t the desired value from 1
to 99 minutes. Press the OK button l to confirm. With
programmed sleep-timer the LCD display q shows "
on the right next to the time.
- 17 -
z "
z