Help - BT RESPONSE 5 User Manual

Help

this section gives you the most common, easy-to-follow solutions
No dialling tone on telephone
Check that your telephone is
correctly connected to the socket on
the back of your Response 5 and
that your Response 5 is connected to
the BT wall socket.
LED does not light up
Check that your Response 5 is
correctly connected to the mains
power socket and that the power is
switched on. Check that the power
cable is inserted into the socket on
the back of the machine.
Outgoing message does not
record
Speak clearly, close enough (15-30
cm) to the microphone when
recording your message.
Make sure the MC30 cassette is
inserted properly.
Check that the volume is not set to
minimum.
If you have any problems using your Response 5,
Messages indicated, but none
recorded
This may happen if your caller
hangs up after your machine starts
recording.
Your Response 5 will terminate a
call under certain conditions
• If a caller pauses for more than
6 seconds when leaving messages.
• If the end of the tape is reached
during recording.
• If the length of the incoming message
is longer than one minute.
The messages are distorted or
poor quality
The early part of the tape may
experience heavy wear and dirt may
accumulate on the tape heads.
Always make sure the cassette area
is free of dirt and dust.
Every three months it is a good idea
to turn the tape over. You will have
to re-record your outgoing message.
16