Back Panel; Auxiliary Battery Well; Usb Port; Rs232 Port - Honeywell Dolphin 6000 User Manual

Back Panel

RS232 Port

Auxiliary Battery Well

The HomeBase can charge an additional Li-ion battery pack in 4 hours in the well behind the terminal. This feature ensures
that you can always have an additional fully-charged battery for Dolphin 6000 terminal. See
Auxiliary Battery Well on page

USB Port

This USB Port is full-speed and 2.0 compliant. Using a USB cable, you can connect the base to a peripheral device, such
as a workstation. When the terminal is seated in the terminal well, it is connected to the workstation device via the base.
RS232 Port
Use the 9-pin, RS232 cable from Honeywell to connect this port to a peripheral device for RS232 data communication. For
more information, see

DC Power Jack

Use the power cable from Honeywell that comes with HomeBase to supply power to this power jack. For more information,
see the Power on page 12-3

Power

The terminal requires 5V, 2A DC input for communications and battery charging; the power adapter on power cable converts
voltage from the power source to 5V, 2A DC. Only the Honeywell 5 VDC, 2A power supply provided with the HomeBase con-
verts the voltage correctly.
It is recommended that the HomeBase be left connected to its power source at all times, so that it is always ready to use.
1. Connect adaptor barrel plug to DC jack on rear panel of HomeBase
2. Plug adaptor AC to the indoor wall receptacle.

Serial Connector

The following diagram shows pin diagram of serial connector of HomeBase.
Auxiliary Battery Well
USB Port
12-5.
Serial Connector on page
section that follows.
DC Power Jack
12-3.
Charging a Battery in the
12 - 3