Enabling The Gsm Radio; Voice Communication; Audio Modes; Volume Control - Honeywell Dolphin 6000 User Manual

8. Lock the SIM card latch by sliding the latch toward bottom of terminal.
9. Install the battery.
10. Install and lock the battery door.
11. Power on the terminal.

Enabling the GSM Radio

By default, the GSM radio is not enabled after a hard reset. Verify the status of the radio in the Dolphin Wireless Manager.
Tap > Settings > Connections > Dolphin Wireless Manager (WLAN).
If the Phone is set to OFF, tap the Phone rectangle and the GSM radio enables.

Voice Communication

Dolphin 6000 terminal can operate as a phone over GSM radio.

Audio Modes

Hands-free Hands-free mode is when you use the rear speaker as a speakerphone. To switch to
Mode speakerphone, tap on the speaker button in the Dialer window.

Volume Control

Press the up or down arrow on the Volume Control button on left side of terminal to adjust volume of speaker. For more informa-
tion, see Volume Control Button, page 3-5.

Accessing the Dialer Window

Tap > Phone or press the Green Call button.
9 - 3