Yamaha FJR1300A Owner's Manual page 82

PERIODIC MAINTENANCE AND ADJUSTMENT
TIP
The oil level should be at the brim of the
filler hole.
1
3
2
1. Final gear oil filler bolt
2. Gasket
6
3. Correct oil level
3. If the oil is below the brim of the fill-
er hole, add sufficient oil of the rec-
ommended type to raise it to the
correct level.
4. Check the gasket for damage, and
replace it if necessary.
5. Install the final gear oil filler bolt
and its gasket, and then tighten the
bolt to the specified torque.
Tightening torque:
Final gear oil filler bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
To change the final gear oil
1. Place the vehicle on a level sur-
face.
2. Place an oil pan under the final
gear case to collect the used oil.
3. Remove the final gear oil filler bolt,
the final gear oil drain bolt and their
gasket to drain the oil from the final
gear case.
2
3
1. Final gear oil filler bolt
2. Gasket
3. Final gear oil drain bolt
4. Install the final gear oil drain bolt
and its new gasket, and then tight-
en the bolt to the specified torque.
6-15
Tightening torque:
Final gear oil drain bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
5. Refill with the recommended final
gear oil to the brim of the filler hole.
Recommended final gear oil:
Yamaha genuine shaft drive gear oil
SAE 80 API GL-5
Oil quantity:
0.20 L (0.21 US qt, 0.18 Imp.qt)
6. Check the oil filler bolt gasket for
damage, and replace it if neces-
sary.
7. Install the oil filler bolt and its gas-
ket, and then tighten the bolt to the
1
specified torque.
2
Tightening torque:
Final gear oil filler bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
8. Check the final gear case for oil
leakage. If oil is leaking, check for
the cause.