Yamaha FJR1300A Owner's Manual page 29

TRIP-F → Display–1 → Display–2 →
Display–3 → TRIP-F
To reset a tripmeter, use the select
switch to select the information display
that contains the tripmeter. Push the
"RESET" button briefly so that the trip-
meter flashes, and then push the "RE-
SET" button again for at least 2
seconds while the tripmeter is flashing.
If you do not reset the fuel reserve trip-
meter manually, it will reset itself auto-
matically and the display will return to
the prior mode after refueling and trav-
eling 5 km (3 mi).
Estimated traveling range display:
RANGE
11
The distance that can be traveled with
the remaining fuel in the fuel tank under
the current riding conditions is shown.
INSTRUMENT AND CONTROL FUNCTIONS
Elapsed time display:
TIME TRIP
The time that has elapsed since the key
was turned to "ON" is shown. The max-
imum time that can be shown is 99:59.
This display is automatically reset when
the key is turned to "OFF".
TIP
There are also "TIME–2" and "TIME–3"
elapsed time displays, but they cannot
be set to the information display. See
"Setting mode" on page 3-16 for de-
tailed information.
Ambient temperature display:
km
A.TEMP
This display shows the ambient tem-
perature from –9 °C to 50 °C in 1 °C in-
crements. The temperature displayed
may vary from the ambient tempera-
ture.
TIP
0:06
Coolant temperature display:
˚C The coolant temperature display indi-
25
cates the temperature of the coolant.
The coolant temperature varies with
changes in the weather and engine
load.
If the message "Hi" flashes, stop the ve-
hicle, then stop the engine, and let the
engine cool. (See page 6-38.)
3-14
● –9 °C will be displayed even if the
ambient temperature falls below
–9 °C.
●
50 °C will be displayed even if the
ambient temperature climbs above
50 °C.
●
The accuracy of the temperature
reading may be affected when
riding slowly [approximately under
20 km/h (12.5 mi/h)] or when
stopped at traffic signals, railroad
crossings, etc.
C.TEMP
Lo
3
˚C