Yamaha FJR1300A Owner's Manual page 31

●
The "L/100km" display shows the
amount of fuel necessary to travel
100 km.
● For the UK only: The "MPG" dis-
play shows the distance that can
be traveled on 1.0 Imp.gal of fuel.
TIP
If traveling at speeds under 10 km/h, "_
_._" will be displayed.
NOTICE
If there is a malfunction, "– –.–" will
be continuously displayed. Have a
Yamaha dealer check the vehicle.
Setting mode
MENU
Grip Warmer
Maintenance
Time Trip
Unit
Display
Brightness
Clock
1. Setting mode display
INSTRUMENT AND CONTROL FUNCTIONS
TIP
● The transmission must be in neu-
tral and the vehicle must be
stopped to change settings in this
mode.
●
Shifting the transmission into gear
and starting off, or turning the key
to "OFF", saves all settings made,
then exits the setting mode.
Push and hold the menu switch
ECA15473
"MENU" for at least 2 seconds to enter
the setting mode. To exit the setting
mode and return to the normal display,
push and hold the menu switch
"MENU" again for at least 2 seconds.
Display
This function allows you to
set the low, middle, and
"Grip Warmer"
high settings to 10 temper-
ature levels.
This function allows you to
set the oil change interval
(distance traveled) and 2
1
"Maintenance"
other maintenance inter-
vals. This function can also
be reset.
Description
3-16
This function allows you to
check and reset the
"TIME–2" and "TIME–3"
functions. These time trips
show the total elapsed
time that the key has been
"Time Trip"
in the "ON" position. When
the key is turned to "OFF",
the trip times stop counting
but are not reset. The max-
imum time that can be
shown is 99:59.
This function allows you to
switch the fuel consump-
tion units between
"L/100km" and "km/L".
For the UK only: This func-
tion allows you to switch
"Unit" the display units between
kilometers and miles.
When kilometers are se-
lected, the fuel consump-
tion units can be switched
between "L/100km" and
"km/L".
This function allows you to
"Display" change the items shown in
3 information displays.
This function allows you to
adjust the brightness of the
"Brightness" multi-function meter unit
panel to suit the outside
lighting conditions.
This function allows you to
"Clock"
set the clock.
3