Printing On Custom Size Paper/Long Paper; Loading Custom Size Paper - Xerox DocuPrint 240A User Manual

2.4

Printing on Custom Size Paper/Long Paper

This section explains how to print on custom size paper such as long paper.
The paper sizes that can be set on this printer are as follows:
* To load long-size paper with the long
edge exceeding 356 mm, load the
paper with the edge protruding from
the tray
Important
• Print quality on the part of the paper that extends beyond 356 mm cannot be guaranteed.

Loading Custom Size Paper

The way to load custom size paper with the long edge shorter than 356 mm in trays 1 to 4
is the same as loading standard size paper. For details, refer to "3.2 Loading Paper" (P. 58).
To load long paper in tray 1, follow the procedure below:
1. Pull the paper tray out to its maximum.
Note
• Pull the extendable part out to its maximum. For
details on the procedure to extend the paper tray, refer
to "3.2 Loading Paper" (P. 58).
2. Load the paper with the side to be printed
facing up. Curl up the back end of the paper
so that it will not fall from the tray.
3. Push the paper tray completely into the printer.
Important
• Do not close the lid of the paper tray.
For tray 1
Long edge:
127 to 900 mm
Short edge:
76 to 216 mm
For trays 2 - 4
Long edge:
148 to 356 mm
Short edge:
98 to 216 mm
2.4 Printing on Custom Size Paper/Long Paper
27