Zoom Wireless-N User Manual page 33

Note: Hybrid mode allows wired and wireless access to the Wireless-N 4-port Router;
WDS Only does not allow wireless access to the Wireless-N 4-port Router. Most users
should select Hybrid mode.
8
From the Scanned AP's MAC drop-down menu, select the SSID (Wireless Network
Name) of the AP (your Router is in Access Point mode when it broadcasts wirelessly)
you want to connect to. The Scanned AP's MAC drop-down menu displays both the
MAC address and SSID of the Wireless Networks that it has found. Make a note of
what wireless channel and the type of security the AP you are connecting to is using.
9
From the Remote AP MAC drop-down menu, select the number of the field you want
the MAC Address to be copied to, then click Copy to. Most users should select 1 to
copy it to the first field.
10
Click Save to save your WDS settings.
11
Next, set up the Wireless-N 4-port Router to use the same wireless channel and security
as the AP you just connected to. Click Wireless from the left-side menu to go to the
main wireless page.
12 Select the Channel that the AP you just connected to is using from the drop-down
menu.
13
Then select the Security type and enter the corresponding Key. Then click Save.
14 If this Wireless-N 4-port Router is not connected directly to your Cable or ADSL
modem you should disable DHCP on the Wireless-N 4-port Router.. Disabling DHCP
means that only the router connected to your modem will assign IP addresses.
To disable DHCP on the Wireless-N 4-port Router:
•
Click LAN Setup from the menu.
•
At the DHCP Server, select Disable. Then click Save.
•
Click Reboot. At the message prompt, click OK.
•
Close the browser. (You do not need to wait for it to reboot.) Then reboot the
PC.
Note: If you had to unplug any cables or make any changes to the computer that you used to
configure the Wireless-N 4-port Router you now should restore that computer back to its original
state.
Congratulations! Your Wireless-N 4-port Router is now setup in Repeater mode. If you need
help connecting additional computers or devices to your Wireless-N 4-port Router please refer to:
Chapter 5, Setting up a Network
devices through the Wireless-N 4-port Router's Ethernet ports.
Chapter 6, Connecting Wireless Devices to the Wireless-N 4-port Router
connecting wireless computers, phones, tablets and game stations.
In the unlikely event you need to make changes to the Wireless-N 4-port Router's advanced
settings please see Chapter 7, Using the Configuration Manager's Advanced
Chapter 5: Using the Configuration Manager's Advanced Program
for help on adding other computers or network
for help on
Program.