Zoom Wireless-N User Manual page 10

Manually Selecting your WAN Type
If you selected Setup your WAN Connection Manually or the manual setup option page
below appears after you run Auto Detect, select your connection from the following options:
•
Dynamic IP Address: Select this if you are using a cable modem or if your ADSL
modem does not use PPPoE. Most users will select this. (ADSL service providers will
typically tell you whether you are using PPPoE, which requires you to enter a
PPPoE-related password into the Router. If you are using ADSL with 1483 routed,
bridged, or PPPoA modes, you are not using PPPoE.)
•
PPPoE: Select this if you are using an ADSL Router with PPPoE.
•
Static IP Address: Typically you must request and pay extra for a static IP. In the
unlikely event that you have done this, select Static IP Address.
•
L2TP: The Layer 2 Tunneling Protocol is more common in corporate environments
and most users will not use this setting. In the unlikely event that you are using a VPN to
access a network that uses Layer 2 Tunneling Protocol, select this option.
•
PPTP: The Point to Point Tunneling Protocol is more common in corporate
environments and most users will not use this setting. In the unlikely event that you are
using a VPN that uses Point to Point Tunneling Protocol, select this option.
Note: If you read the discussion above and are still unsure which WAN Type to choose,
please check with your service provider.
Click Next.
The relevant section immediately below depends on the WAN Type you selected.
10 Wireless-N 4-port Router User Manual