Panasonic BT-4LH310P Operating Instructions Manual page 33

Main Menu
(Continued)
Submenu
POWER DOWN OFF
ON
POWER SAVE MODE OFF
ON
LED BRIGHT HIGH
LOW
CALIBRATION
„ Panasonic Camera Recorders and Stop Signals (Recording Mark)
Model Recording Mark TYPE
AJ-HDC27F, H TYPE1
AJ-HDX900
TYPE1 / TYPE2
AJ-HDX400, A
AJ-HDX400E
AG-HPX555
AG-HPX175
AG-HPX305
AG-HPX375
AJ-HPX2100
AJ-HPX3000
AJ-HPX2700
AJ-HPX3100
AJ-HPX3700
<Note>
For details, refer to operating instructions for the corresponding camera recorders.
Setting
Sets whether to turn off the power (power down) when no signal is input and
no operation was performed for approximately 1 hour.
[OFF] Not powered down.
[ON] Powered down.
Sets the power save mode
[OFF] Power save mode is not enabled.
[ON] Dims the backlight when the state of no signal being input ([NO
SIGNAL]) continues for approximately 60 seconds. Signal input or
menu operation restores the backlight to its normal brightness.
Sets the brightness of the lamps (green) on the front of the unit.
[HIGH] High brightness mode
[LOW]
Connect a CA-310 Display Color Analyzer and then execute calibration. The
calibration data will also be restored to the factory defaults. (→ page 35, 36)
Before use with TYPE1, change the UB_MODE
setting on the camera to FRAM_RATE, and
before use with TYPE2, change the VITC_UB_
MODE setting on the camera to FRAM_RATE.
Description
Low brightness mode
Remarks
33