Panasonic BT-4LH310P Operating Instructions Manual page 32

Main Menu
(Continued)
Submenu
SDI4 FORMAT AUTO
3G 4:2:2 YCbCr 10bit
3G 4:4:4 YCbCr 10bit
3G 4:4:4 RGB 10bit
3G 4:2:2 YCbCr 12bit
3G 4:4:4 YCbCr 12bit
3G 4:4:4 RGB 12bit
3G 4:4:4 XYZ 12bit
MAIN MENU LT
POSITION RT
RB
LB
STATUS DISPLAY OFF
3SEC OFF
CONTINUE
CRCC ERROR OFF
ON
PAYLOAD ID ERROR OFF
ON
SDI REC TALLY OFF
TYPE1
TYPE2
TYPE3
INPUT NAME SETUP
SETUP LOAD FACTORY
USER1
USER2
USER3
USER4
USER5
SETUP SAVE USER1
USER2
USER3
USER4
USER5
POWER ON SETUP LAST
FACTORY
USER1
USER2
USER3
USER4
USER5
*
1
When PIXEL TO PIXEL, [3SEC OFF] is equivalent to [CONTINUE].
*
2
Up to 12 characters can be entered for this monitor. Only alphabetic characters (English), numeric characters and symbols can be
used.
*
3
[USER1] to [USER 5] and [FACTORY] have the same factory defaults.
32
Setting
Selects the SDI4 input format.
• For each item, refer to [SDI1 FORMAT].
Sets the display position of the main menu.
[LT] Top left of the screen
[RB] Bottom right of the screen
Determines how (→page 16) operating status is displayed.
[OFF]
[3SEC OFF]
[CONTINUE] Always displayed
Displays a CRCC error for SDI.
[OFF] Not displayed
[ON]
Displays a payload ID error for SDI.
[OFF] Not displayed
[ON]
Lights the red tally when SDI REC information is superimposed.
[OFF]
[TYPE1] Lights the red tally in accordance with the record/stop signal in the
[TYPE2] Lights the red tally in accordance with the record/stop signal in the
[TYPE3] Checks the information when another company's camera recorder
<Note>
• For details on TYPE1 or TYPE2, refer to "Panasonic Camera Recorders and
Record/Stop Signals (Recording Mark)" (→page 33).
• When [GPI CONTROL] is [ENABLE] and the tally item is assigned, tally
control from the GPI takes priority.
Changes the names of the input connectors to be displayed on the status
display screen and other screens.
Loads the saved factory defaults ([FACTORY]) or user data ([USER1] to
[USER5]). (→page 22)
*
3
After user data is loaded, the screen displays the signal selected before the
*
3
user data was loaded.
*
3
*
3
*
3
Saves up to 5 sets of user data. (→page 22)
Menu settings, except [SETUP SAVE]/[SETUP LOAD], and adjustment
values made with the rotary knob <PICTURE> can be saved.
Selects the settings to use when the power is turned on.
[LAST]
[FACTORY]
[USER1] to [USER5] Starts up using USER registered settings.
Description
Not displayed.
Displayed for approximately 3 seconds after a status change.
Displayed
Displayed
Not displayed
LTC information added to the HD SDI.
SVITC information added to the HD SDI.
is used and lights the red tally accordingly.
*
Starts up using the settings used immediately before
the power was turned off.
Starts up using the factory defaults.
[RT] Top right of the screen
[LB] Bottom left of the screen
2
*
1