Setting The Alarm Clock; Using Several Handsets; Registering Handsets - Siemens Gigaset SL785 Instructions Manual

Setting the alarm clock

If 10 entries are already stored in the list,
the next appointment reminder will delete
the oldest entry.
Setting the alarm clock
Precondition: The date and time have
¢
already been set (
Activating/deactivating the alarm
clock and setting the wake-up time
Í
¢ ¢
v
Alarm Clock
¤
Change multiple line input:
Activation:
Select or Off.
On
Time:
Enter the wake-up time in 4-digit for-
mat.
Occurence:
Select or Monday-Friday.
Daily
Volume:
Set the volume (1–6).
Melody:
Select melody.
Press the display key.
§Save§
¼
In idle status, the
time are displayed.
A wake-up call is signalled on the display
and with the selected ring tone
¢
( page 3). The wake-up call sounds for
60 seconds. If no key is pressed, the wake-
up call is repeated twice at five minute
intervals and then turned off.
During a call, the wake-up call is only sig-
nalled by a short tone.
Deactivating the wake-up call/
repeating after a pause (snooze mode)
Precondition: A wake-up call is sounding.
Press the display key. The
§Off§
wake-up call is deactivated.
or
58
page 16).
icon and wake-up
Press the display key or any
§Snooze§
key. The wake-up call is deacti-
vated and then repeated after
5 minutes. After the second
repetition the wake-up call is
deactivated completely.

Using several handsets

Registering handsets

You can register up to six handsets to your
base.
A Gigaset SL78H handset can be regis-
tered on up to four bases.
Manually registering the
Gigaset SL78H to the Gigaset SL780/
SL785
You must activate manual registration of
the handset on both the handset and the
base.
Once it has been registered, the handset
returns to idle status. The handset's inter-
nal number is shown in the display
e.g. 1. If not, repeat the procedure.
INT
On the handset
The handset must not be registered to a
base.
Press the display key.
§Register§
The handset is already registered to a
base:
Ï
¢ ¢
v
Registration
¢
Register Handset
s
Select base, e.g.
press
§OK§
~
If required, enter the system
PIN for the base and press
A message displays that a search for a base
that is ready for registration is being car-
ried out.
and
Base 3
.
§OK§
.