Table of Contents
Advertisement
Using a handset as a room monitor
When the room monitor is activated,
incoming calls to the handset are indi-
cated without a ring tone and are only
shown on the screen. The display and key-
pad are not illuminated and advisory
tones are also turned off.
If you accept an incoming call, the room
monitor is suspended for the duration of
the call, but the function remains acti-
vated.
If you deactivate then reactivate the hand-
set, the room monitor remains activated.
Warning!
u
You should always check the
operation of the room monitor
before use. For example, test its
sensitivity. Check the connection
if you are diverting the room
monitor to an outside number.
u
When the function is switched on,
the handset's operating time is con-
siderably reduced. If necessary,
place the handset in the charging
cradle. This ensures that the battery
does not run down.
u
Ideally the handset should be posi-
tioned 1 to 2 metres away from the
baby. The microphone must be
directed towards the baby.
u
The connection to which the room
monitor is diverted must not be
blocked by an activated answering
machine.
Activating the room monitor and
entering the destination number
É
¢
¢
v
Room Monitor
¤
Change multiple line input:
Activation:
Select
On
to activate.
62
Alarm to:
Select
or External.
Internal
External number: Select the number
from the directory (press display key
ö
) or enter it directly.
Internal number: Select display key
¢
Select handset or
§Change§
you want to call all registered handsets
¢
.
§OK§
In idle status, the destination number
or the internal destination number is
displayed.
Sensitivity:
Select noise level sensitivity
High).
¤
Press
to save the settings.
§Save§
When the room monitor function is acti-
vated, the idle display looks as shown
below:
i Ã
V
INT 1
Á
07:15
2008
Oct
Room Monitor active
0891234567
Off
Options
Changing the set destination number
É
¢
¢
v
Room Monitor
¤
Enter and save number as described in
"Activating the room monitor and
entering the destination number"
¢
(
page 62).
Cancel/deactivate room monitor
Press the end call key a to cancel the
call when the room monitor is activated.
In the idle status press the display key
to deactivate the room monitor mode.
Call All
if
(Low
or
§Off§
Advertisement
Table of Contents
