Mazda 3 Owner's Manual page 341

Interior Features
®
Bluetooth
NOTE
®
Some Bluetooth audio devices need a
certain amount of time before the
symbol is displayed.
If the programming failed, " Err "
fl ashes for three seconds .
Programming cannot be performed
while the vehicle is moving. If you
attempt to perform programming
while the vehicle is moving, " PAIR
DISABLE " is displayed .
®
If seven Bluetooth
have already been programmed to
the vehicle, programming cannot be
performed and " MEMORY FULL "
is displayed. Delete one programmed
device to program another one.
Programming a Bluetooth
which does not have a four-digit PIN
code
1. Using the audio control dial, select
the pairing program mode " PAIR
DEVICE " in the " BT SETUP " mode.
(Refer to "Bluetooth
details.)
2. Press the audio control dial to
determine the mode. After " ENTER
PIN " is displayed on the audio display
for three seconds, " PIN 0000 " is
displayed and the PIN code can be
input.
3. Press the audio control dial while " PIN
0000 " is displayed. " PAIRING " fl ashes
on the audio display.
4. Operate the Bluetooth
and set it to the program mode while
" PAIRING " is fl ashing.
®
5. As the Bluetooth
requires a PIN code, input "0000".
5–84
audio devices
®
audio device
® audio set up" for
®
audio device
audio device
6. When the programming is completed,
and " PAIR SUCCESS " are displayed
after about 10-30 seconds, after which
" PAIR SUCCESS " continues to be
displayed for three seconds, and then
the unit returns to the normal display.
NOTE
If pairing cannot be completed, try
"1234" instead. Refer to the owner's
manual of your mobile device for the
right PIN code.
®
Some Bluetooth audio devices need a
certain amount of time before the
symbol is displayed.
If the programming failed, " Err "
fl ashes for three seconds.
Programming cannot be performed
while the vehicle is moving. If you
attempt to perform programming
while the vehicle is moving, " PAIR
DISABLE" is displayed .
If seven Bluetooth ®
have already been programmed to
the vehicle, programming cannot be
performed and " MEMORY FULL "
is displayed. Delete one programmed
device to program another one.
Device selection
If several devices have been programmed,
®
the Bluetooth unit links the device last
programmed. If you would like to link
a different programmed device, it is
necessary to change the link. The order
of device priority after the link has been
changed is maintained even when the
ignition is switched off.
1. Using the audio control dial, select the
link change mode " LINK CHANGE "
in the " BT SETUP " mode. (Refer to
®
"Bluetooth audio device set-up" for
details.)
audio devices